Keri-systems NXT RIM Uživatelský manuál stáhnout pdf (Strana 4)

NXT Reader Interface Module

Installation Guide

Page 4 of 5 P/N: 02501-001 Rev. L

3.4 Verifying RIM Configuration

The corresponding reader type and line control mode LEDs are illuminated during operation. Refer to

the Drawing on page 1 for switch and LED locations, and the Table on page 2 for switch and LED

definitions to confirm your configuration settings.

Table 2: Reader Interface Module LED Guide

LED Reader Type

D4 Keri MS Series

Keri factory default setting

D5 Wiegand

D6 Keri NXT-6RK Keypad

D7 Wiegand Reader/Keypad Combo

LED Control

D1 single wire LED control – red, green, amber, off

D2 two wire LED control – red, green, amber, off

Keri factory default setting

a. Table is valid for RIM Firmware v03.01.06 and later. Please upgrade your firmware as necessary.

single wire LED control – red, green, off

standard setting for Wiegand Readers using a single wire to drive the

LED (no amber)

Communication Active

D8 RS-485 Bus

J2 Reader Power Setting

D10 lit when set for 12 VDC reader power

1 2 3 4 5

Žádné komentáře

Keri-systems NXT RIM Uživatelský manuál Strana 4